Hard to crank in either gear
The most common cause is dry, dirty gears inside the legs. Dirt, rust and old grease build up, especially on trailers that sit in the weather. Sometimes lubrication brings it back. If it still binds, the internal gears or the cross shaft may be worn or damaged.
Crank spins but the legs don't move
This usually means a broken or sheared pin, a stripped gear, or a failed connection in the cross shaft between the two legs. If only one leg moves, the cross shaft is a likely suspect.
Legs slip or drop under load
Gear teeth that are worn or chipped can slip when the weight of a loaded trailer is on them. This is dangerous — a trailer that drops while someone is near it can cause serious injuries. Stop using it and get it repaired.
Bent legs
Landing gear gets bent when a trailer is dropped on uneven ground, when the truck pulls away before the legs are fully cranked up, or when a leg hits something. A bent leg won't crank smoothly and may not hold weight properly. Bent legs usually need to be replaced, not straightened.
Damaged sand shoes or feet
The feet at the bottom of the legs can crack, break off or get torn up. Damaged feet sink into soft ground and put uneven stress on the legs.
Prevent landing gear problems
- Crank the legs all the way up before pulling out
- Drop trailers on firm, level ground whenever possible
- Use pads or boards under the feet on soft ground or hot asphalt
- Lubricate the gears on a regular schedule
- Don't crank against the full weight in high gear — shift to low gear
Landing gear repairs we do
- Lubrication and freeing up stuck gear
- Cross shaft and crank handle replacement
- Replacing bent or worn-out landing gear legs
- New feet and sand shoes
More trailer repair guides · All services · ZIP codes we serve