
Electric brakes (utility, equipment, hotshot and gooseneck trailers)
Check the brake controller first
If the controller in your truck shows no trailer connected or an error, the problem may be the plug, the wiring or the controller itself — not the brakes. Make sure the gain is set correctly for the load.
Wiring and grounds
Most electric brake problems are wiring. Corroded 7-way plugs, broken wires along the frame and bad ground connections are very common, especially on trailers that sit outside in Houston humidity. One bad ground can make all the brakes weak.
Worn brake magnets
The magnet is what grabs the drum and applies the shoes. Magnets wear out over time and can short out. A worn magnet often leaves a grooved pattern and makes one wheel brake weaker than the others.
Worn shoes or grease on the shoes
Brake shoes wear down like any brake. If a hub seal has leaked, grease can soak the shoes — once that happens, the shoes usually need replacing, along with the seal that caused it.
Breakaway system
If your trailer has a breakaway kit, make sure the battery is charged and the switch works. It's what stops the trailer if it ever separates from the truck.
Air brakes (semi trailers)
Air leaks
A hissing sound around the gladhands, air lines, valves or brake chambers means you're losing air. Leaks can keep brakes from applying fully or releasing properly.
Brake chambers
A cracked diaphragm or failed spring brake chamber can leave one wheel position with weak brakes or brakes that won't release.
Slack adjusters out of adjustment
If push-rod stroke is too long, the brakes won't apply with full force. Automatic slack adjusters can stick or wear out and stop adjusting.
Worn shoes and drums
Cracked, heat-checked or worn-out drums and thin shoes all reduce stopping power.
Signs you need brake work now
- The trailer pushes the truck when you stop
- One wheel locks up or one side pulls
- Grinding or metal-on-metal noise
- A hub that's much hotter than the rest after driving (dragging brake)
- Visible grease on the inside of the wheel
What a trailer brake job can include
- New brake shoes and hardware
- New magnets (electric brakes) or chambers and slack adjusters (air brakes)
- Hub and drum replacement if the drum is worn past spec or damaged
- New bearings and seals, with fresh grease
- Wiring repairs from the plug back to each brake
Service page: Brake repair in Houston
More trailer repair guides · All services · ZIP codes we serve